Connection Plar

Answered Question
Mar 11th, 2009
User Badges:

I just have a quick question. On a voice port config, when specifying the connection PLAR, do I need to configure the number that is called to ring the port (as in the DID to that line) or do I specify the digits I want forwarded to the CUCM/CME?


I hope that question makes sense. Another way to ask, if someone's DID is 1-800-111-1111 but their internal extension is 2222, would the plar on that voice port be 1111, or 2222?


Or, does it just specify the dial peer to match?


Correct Answer by Brandon Buffin about 8 years 1 week ago

The following document references CCM 3.x/4.x. However, if you're using a later version, the concepts still apply.


http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080094636.shtml


Hope this helps.


Brandon

Correct Answer by Brandon Buffin about 8 years 1 week ago

You would specify the DN (internal extension).


Hope this helps.


Brandon

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
Brandon Buffin Wed, 03/11/2009 - 10:51
User Badges:
  • Purple, 4500 points or more

You would specify the DN (internal extension).


Hope this helps.


Brandon

gmgarrian Wed, 03/11/2009 - 11:32
User Badges:

It does and it works.


Thanks!


Now I have to figure out outbound calls...

Brandon Buffin Wed, 03/11/2009 - 11:54
User Badges:
  • Purple, 4500 points or more

Here's an example of a dial peer for outbound calls:


dial-peer voice 1 pots

destination-pattern 9[2-9]......

forward-digits 7

port 0/0/0


This dial peer will match 7 digit calls with a prefix of 9 and send 7 digits out port 0/0/0. This will essentially strip the 9 before sending the call.


Hope this helps.


Brandon

gmgarrian Wed, 03/11/2009 - 12:01
User Badges:

I've got the outbound dial peer configured for pattern 9T

I'm now figuring out what to do to get the CUCM server to send outbound calls to the H.323 Gateway. I can't find where to do that...

gmgarrian Wed, 03/11/2009 - 12:16
User Badges:

I think that did it. I didn't know that I needed to put the IP address in the "name" location.


Thanks again!

Actions

This Discussion