03-11-2009 01:29 PM - edited 03-15-2019 04:47 PM
Hi team
How Can I configure DDI for CCME
My DDI Range 2303320-29
and me Phone Number 501 -509
Brgds
Solved! Go to Solution.
03-12-2009 09:18 AM
A nitpick: your DP 300 doesn't need port. port is never used for incoming DP.
Please remember to rate useful posts with the scrollbox below.
03-11-2009 05:18 PM
hi there
just make incoing translation profile and apply it to your pots dial-peer
this one take only las three digits
and on each ephon-dn
creat a number with a secondary number
for eaxmple lets say call coming to last three digits 320 should go to extention 501
ephone-dn 1 dual-line
number 501 secondary 320
good luck
if helps Rate
03-11-2009 08:44 PM
There are two methods, dialplan-pattern and translation rules. I recommend the second especially if you have CUE.
voice translation-profile makedid
translate called 10
voice translation-rule 10
rule 1 /230332/ /50/
voice-port x/y/z
translate incoming makedid
03-12-2009 08:27 AM
Dear All
Problem solved
I add
voice translation-rule 506
rule 1 /21/ /501/
rule 2 /22/ /502/
rule 3 /23/ /503/
rule 5 /25/ /505/
voice translation-profile 506
translate called 506
voice-port 0/3/0
translation-profile incoming 506
dial-peer voice 3300 pots
translation-profile incoming 506
incoming called-number .
direct-inward-dial
port 0/3/0
03-12-2009 09:18 AM
A nitpick: your DP 300 doesn't need port. port is never used for incoming DP.
Please remember to rate useful posts with the scrollbox below.
03-12-2009 10:42 AM
Great
Thank for yoy advice p.bevilac
Brgds
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: