03-12-2009 12:22 AM
Hello.
I'm looking for a ASDM guide to implement L2L tunnel between a ASA 5510 with static ip and a device with a dynamic ip. I relly suck when it comes to CLI so I would like some help setting this up via ASDM. I've got it working once but that was a long time ago so i don't remember the way of doing this. I think it all went bad when I added a Remote Access VPN for a client.
03-12-2009 03:10 AM
Below are the config examples for PIX/ASA:-
http://www.cisco.com/en/US/products/ps6120/prod_configuration_examples_list.html
HTH>
03-12-2009 08:47 AM
Follow up.
I'm getting theese errors:
Group = DefaultRAGroup, IP = x.x.x.x, Removing peer from peer table failed, no match!
03-12-2009 09:12 AM
That is because you have not configured a dynamic CRYPTO group for remote VPNs - check your config.
HTH>
03-12-2009 11:43 AM
yes, it was the Linksys router with the dynamic ip that only could authanticate with ip and not name.
It's working now with a different router.
03-12-2009 01:28 PM
np - glad to help.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: