Guys,
I am having an issue with mgcp registration.
On the serial port..I am unable to configure the isdn bind-l3 ccm-manager command. The iso version is
c3845-spservicesk9-mz.124-15.T5.bin.
All that is available is isdn bind-l3 q931/q921.
When I issue a sh ccm-manager, the gateway shows evrything as registered.
The output of sh ccm-manager is below
OCVG01#sh ccm-manager
MGCP Domain Name: OCVG01.test.production.uk
Priority Status Host
============================================================
Primary Registered 10.128.250.128
First Backup Backup Ready 10.34.161.161
Second Backup None
Current active Call Manager: 10.128.250.128
Backhaul/Redundant link port: 2428
Failover Interval: 30 seconds
Keepalive Interval: 15 seconds
Last keepalive sent: 11:06:41 gmt Mar 12 2009 (elapsed time: 00:00:05)
Last MGCP traffic time: 11:06:41 gmt Mar 12 2009 (elapsed time: 00:00:05)
Last failover time: 10:56:14 gmt Mar 12 2009 from (10.128.250.128)
Last switchback time: 10:56:29 gmt Mar 12 2009 from (10.34.161.161)
Switchback mode: Graceful
MGCP Fallback mode: Not Selected
Last MGCP Fallback start time: None
Last MGCP Fallback end time: None
MGCP Download Tones: Disabled
TFTP retry count to shut Ports: 2
FAX mode: cisco
Configuration Error History:
OCVG01#
Mar 12 11:06:56.133: MGCP Packet sent to 10.128.250.128:2427--->
NTFY 767469129 *@OCVG01.test.production.uk MGCP 0.1
X: 0
O:
<---
Mar 12 11:06:56.133: MGCP Packet received from 10.128.250.128:2427--->
200 767469129
<---
Also a debug mgcp packet gives me a response code of 200..which shows evrything is fine...
However On callmanager the status shows as unregistered.
The setup is as follows
CCM--3845VG--qsig--PBX.
When I used h.323 on the gateway evrything works.
Here is a the mgcp config
ccm-manager redundant-host 10.34.161.161
ccm-manager mgcp
ccm-manager music-on-hold
ccm-manager config server 10.34.161.161
!
mgcp
mgcp call-agent 10.128.250.128 service-type mgcp version 0.1
mgcp dtmf-relay voip codec all mode out-of-band
mgcp bind control source-interface Loopback0
mgcp bind media source-interface Loopback0
!
mgcp profile default
interface Serial0/0/0:15
no ip address
encapsulation hdlc
isdn switch-type primary-qsig
isdn overlap-receiving
isdn incoming-voice voice
isdn contiguous-bchan
no cdp enable
Please rate all useful posts