sip registration

Unanswered Question
Mar 12th, 2009
User Badges:

UC520 connected to XO using SIP.

Under CCA SIP Trunk tab make the password cisco.

When i logon on thru cli it shows a totally different password.

Can't keep registration live with XO.

How can I disable this encryption feature.

Please help.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Steven DiStefano Thu, 03/12/2009 - 07:56
User Badges:
  • Blue, 1500 points or more

Very Interesting.

Under sip-ua in the CLI, the authentication username password gets set for the SIP SP.  Usually I have seen the 'password 7 ', where 7 means an encrypted password follows, so it wont match what you entered, but it is what you entered :-)

I tried configuring the sip-ua to manually set that to 'password 0 ' and it still shows as 7 , so no luck there.  CCA offers an option in 1.9.1 that lets you show/or not the password for the SIP SP in the GUI, but doesnt impact the way the CLI is sent it looks like.

Perhaps enable the following debug:

debug ccsip messages

...and watch to see if the registration message goes out and is responded to (challenged usually and then responded to with the nonce, which is also a hash of values so you wont see it there either) so at least you can get a little further.

Also do

'sh sip reg stat' to check status manually.

Then you can see where you are perhaps a bit better.....


This Discussion