03-13-2009 01:28 AM
Hello i have question about VPN passthrough i looking for some router with 3DES passthrough about 20Mbps.
In for example RVL200 i cannot find this parametr.
Regards Tomas
03-15-2009 06:13 PM
look on the gui tab called IPSec VPN...there should be a sub tab called "VPN Pass Through"
• VPN pass-through of Point-to-Point Tunneling Protocol (PPTP), Layer 2 Tunneling Protocol (L2TP), IPsec should be supported.
just remember the RVL200 supports 5 SSL tunnels and only 1 IPSec tunnel.... Comparison here...
http://www.cisco.com/en/US/products/ps9923/products_qanda_item09186a0080a36436.shtml
03-16-2009 01:28 AM
Hello Steve,
sorry for my english i means throughput of VPN, end user need throughput about 20Mbps in IPSec VPN with 3DES encryption.
Regards
Tomas
03-16-2009 04:41 AM
I would not use a RVL200 in that case. I dont think it will do 20mbps. More like 14mbps.
I would use RV042 which has 60mbps VPN throughput, perhaps a bit less with 3des as I am not sutre what the operational profile used to determine performance numbers. RV082 is advertised at 90 mbps as an FYI....
03-16-2009 06:37 AM
OK, very good
and have you some table with this parameters for all router?
Regards
Tomas
03-18-2009 07:45 AM
Data Sheets...
http://www.cisco.com/cisco/web/solutions/small_business/products/routers_switches/small_business_routers/index.html
03-18-2009 07:53 AM
Thank you !
I have old one....
Regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: