cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
389
Views
0
Helpful
2
Replies

Invliad boot configuration string on slave

sivaprakasam81
Level 1
Level 1

Hi All,

The Cat6513 with 2 Supervisor engine 720, has an issue with boot string configuration, Please refer the following output. (show dianostic sanity)

6513-01#show diagnostic sanity

Pinging default gateway 192.168.30.1

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 192.168.30.1, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/4 ms

Invalid boot image "sup-bootflash:s72033-ipservicesk9-mz.122-18.SXF11.bin" specified in the boot string on the slave.

Please check your boot string on the slave.

None of the images specified in the boot string on the slave are valid.

Please specify at least one valid image in the slave boot string to ensure the

slave is in a bootable state.

How do i configure the boot image for the salve?

Redundancy mode : SSO

6513-01#dir /all

Directory of sup-bootflash:/

1 -rw- 42827268 Jan 14 2008 17:02:55 -05:00 s72033-ipservicesk9-mz.122-18.SXF11.bin

6513-01#show boot

BOOT variable = sup-bootflash:s72033-ipservicesk9-mz.122-18.SXF11.bin,1;

CONFIG_FILE variable does not exist

BOOTLDR variable =

Configuration register is 0x2102

Standby is up

Standby has 458720K/65536K bytes of memory.

Standby BOOT variable = sup-bootflash:s72033-ipservicesk9-mz.122-18.SXF11.bin,1;

Standby CONFIG_FILE variable does not exist

Standby BOOTLDR variable =

Standby Configuration register is 0x2102

Thank you!

2 Replies 2

Leo Laohoo
Hall of Fame
Hall of Fame

Can you do a "show boot"?

Hi,

6513-01#show boot

BOOT variable = sup-bootflash:s72033-ipservicesk9-mz.122-18.SXF11.bin,1;

CONFIG_FILE variable does not exist

BOOTLDR variable =

Configuration register is 0x2102

Standby is up

Standby has 458720K/65536K bytes of memory.

Standby BOOT variable = sup-bootflash:s72033-ipservicesk9-mz.122-18.SXF11.bin,1;

Standby CONFIG_FILE variable does not exist

Standby BOOTLDR variable =

Standby Configuration register is 0x2102

Thank you!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco