question about FXO trunking

Unanswered Question
Mar 14th, 2009

please see the below partial output of an ISDN voice trunk to the PSTN configuration on a cisco IOS gateway using MGCP to bind to the call manager.

isdn switch-type primary-4ess

controller T1 0/2/1

framing esf

linecode b8zs

pri-group timeslots 1-24 service mgcp

interface Serial0/2/0:23

no ip address

encapsulation hdlc

isdn switch-type primary-4ess

isdn incoming-voice voice

isdn bind-l3 ccm-manager

no cdp enable

My question is how do you configure a Cisco IOS gateway with an FXO trunk to the PSTN to do the same thing. in other words use MGCP and bind to the call manager? Im only concerned with the cisco IOS gateway config. Thanks!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion