cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
667
Views
4
Helpful
9
Replies

Trunk between CUCM 7 and 4.3

imadjabboury
Level 1
Level 1

Dears,

I'm configuring a NonGwtekeeper Controlled trunk between CUCM 7 and CUCM 4.3

Calls from 4.3 to 7 are successful, but the reverse way is not working,

Kindly advice about that.

9 Replies 9

gogasca
Level 10
Level 10

Check Device Pool of trunks and remote IP address. (ie)

cluster A (cucm 4.3) 3 servers

cluster B (cucm 7.0.1) 2 servers

when u configure in cluster A, the ICT,

2 things:

a)ICT Device Pool should have the 3 servers in its CCM group.

b) Remote server should contain 2 IP addresses of remote servers

when u configure in cluster B, the ICT,

2 things:

a)ICT Device Pool should have the 2 servers in its CCM group.

b) Remote server should contain 3 IP addresses of remote servers

HTH

actually i didn't understand well what do u mean.

i only hve one CUCM 7.0.1 and one CUCM 4.3

anyway,

thanks for ur reply.

check Calling search spaces, locations and regions then.

i didn't configure any Calling Search Spaces, those are fresh servers, i'm doing test in our lab.

i did configure locations and regions.

first i need to know if this type of trunk should work successfully, and has been tested.

actually i didn't understand well what do u mean.

i only hve one CUCM 7.0.1 and one CUCM 4.3

anyway,

thanks for ur reply.

Then it does not apply, check Incoming CSS for ICT Trunk.

R u using MTP required?

sorry for the inconvenience

the 4.3 server has configurations, but the CUCM 7 is a new one..

u meant incoming CSS on 4.3

no mtp required

thanks man,

i just needed to check the CSS.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: