03-17-2009 01:47 AM - edited 03-15-2019 04:53 PM
Dears,
I'm configuring a NonGwtekeeper Controlled trunk between CUCM 7 and CUCM 4.3
Calls from 4.3 to 7 are successful, but the reverse way is not working,
Kindly advice about that.
03-17-2009 02:01 AM
Check Device Pool of trunks and remote IP address. (ie)
cluster A (cucm 4.3) 3 servers
cluster B (cucm 7.0.1) 2 servers
when u configure in cluster A, the ICT,
2 things:
a)ICT Device Pool should have the 3 servers in its CCM group.
b) Remote server should contain 2 IP addresses of remote servers
when u configure in cluster B, the ICT,
2 things:
a)ICT Device Pool should have the 2 servers in its CCM group.
b) Remote server should contain 3 IP addresses of remote servers
HTH
03-17-2009 02:09 AM
actually i didn't understand well what do u mean.
i only hve one CUCM 7.0.1 and one CUCM 4.3
anyway,
thanks for ur reply.
03-17-2009 02:12 AM
check Calling search spaces, locations and regions then.
03-17-2009 02:40 AM
i didn't configure any Calling Search Spaces, those are fresh servers, i'm doing test in our lab.
i did configure locations and regions.
first i need to know if this type of trunk should work successfully, and has been tested.
03-17-2009 02:19 AM
actually i didn't understand well what do u mean.
i only hve one CUCM 7.0.1 and one CUCM 4.3
anyway,
thanks for ur reply.
03-17-2009 02:37 AM
Then it does not apply, check Incoming CSS for ICT Trunk.
R u using MTP required?
03-17-2009 02:42 AM
sorry for the inconvenience
the 4.3 server has configurations, but the CUCM 7 is a new one..
u meant incoming CSS on 4.3
03-17-2009 03:14 AM
no mtp required
03-17-2009 06:36 AM
thanks man,
i just needed to check the CSS.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: