QSIG - CME 7.0 and PBX Panasonic

Unanswered Question
Mar 17th, 2009

hi, integrating a PBX with a CME using a PRI-QSIG (E1), seeing the debug "debug isdn q931", i see that the pbx send the connect message, and the cme also sent the connect message to the pbx, but in the cisco phone stills showing "calling", and there is no audio, and not previous ring back.

the calls from the pbx to the cme work fine.

any advice?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion