Problem with re-imaging local controller 210

Unanswered Question
Mar 18th, 2009

I was downloading DVD image vers. 6.0.2. After installation process system not started. On the console i see "LI" communicate. Maybe the image is bad???

What is the solution?

Regards, Pawel

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Farrukh Haroon Mon, 03/23/2009 - 07:11

Compare the MD5 checksum of the image with the one mentioned on the site. If it does not match, re-download the image :).



pawel.swiecki Mon, 03/23/2009 - 12:10

The md5 checksum is correct. During the installation process appears communicates for example:" /cdrom/bin/tar: lib/modules.pcimap: Could not create file: No such file or directory". There are a few similar communicates. After finishing installation process and reboot device I see communicate: "Li".

Maybe the disk storage with RAID is bad?, but under the diagnostic program I can't see problem.

I tried with many versions of software: from 5.3.5 to 6.0.2 - there are similar problems.




This Discussion