Problem with re-imaging local controller 210

pawel.swiecki · ‎03-18-2009

I was downloading DVD image vers. 6.0.2. After installation process system not started. On the console i see "LI" communicate. Maybe the image is bad???

What is the solution?

Regards, Pawel

Farrukh Haroon · ‎03-23-2009

Compare the MD5 checksum of the image with the one mentioned on the site. If it does not match, re-download the image :).

Regards

Farrukh

pawel.swiecki · ‎03-23-2009

The md5 checksum is correct. During the installation process appears communicates for example:" /cdrom/bin/tar: lib/modules.pcimap: Could not create file: No such file or directory". There are a few similar communicates. After finishing installation process and reboot device I see communicate: "Li".

Maybe the disk storage with RAID is bad?, but under the diagnostic program I can't see problem.

I tried with many versions of software: from 5.3.5 to 6.0.2 - there are similar problems.

Regards

Pawel

Farrukh Haroon · ‎03-23-2009

I would open a TAC Case at this point, if that is possible.

Regards

Farrukh