cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
528
Views
0
Helpful
6
Replies

CME cut calls

joseriveros
Level 1
Level 1

Have a Cisco 2811 with IOS c2800nm-entservicesk9-mz.124-22.T.bin, CME Version 7.0(1) two VIC2-4FXO towards PSTN. Alls Call to the PSTN are cut after 2.55 min. approximately

, from any of the FXO ports, Can someone help me with this.

Thanks

6 Replies 6

paolo bevilacqua
Hall of Fame
Hall of Fame

Can you collect "debug vpm signal" and "debug voice ccapi" with "term mon" ?

Ideally, you do this after configuring "service timestamps debug datetime msec localtime".

Send debug CCapi and VPM, the calls of test was to the numbres 9005622442010 and 90056991598950.

Too many calls here and it's all muddled up. Can you get this during a quiet period and get the debugs together?

ok, again sending the debug

The ccapi debugs say the fxo hung up first, and the vpm debugs say the ip phone hung up first.

Can't come to a conclusion when you're getting the debugs separated.

A little note that may be helpful, and for anyone else that may read this - debugs are never more helpful when they're captured separately.

-nick

Jose, beside the good advice from Nick, can you try 12.4(20)T2 that is perhaps a little more stable ?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: