03-18-2009 01:16 PM - edited 03-04-2019 03:59 AM
Hi All,
We are trying to figure out prioritizing voice traffic to around 20 percent of the link bandwidth in the outbound direction on WS-X6408A-GBIC by the below command
policy-map <name>
class <name>
priority percent 20
!
class-map match-any <name>
match access-group <name>
!
ip access-list extended <name>
.When applying the service policy on outbound direction,it gives an error message saying priority command is not supported on outbound direction on this interface.
Is there a way were we could prioritize without using the priority command or I am missing something .
Any help is really appreciated.
Thanks
Regards
Anantha Subramanian Natarajan
03-18-2009 01:30 PM
Anantha
Please don't cross post as it just creates confusion. I have posted an answer in Lan Switching & Routing.
Could we stick to that thread.
Jon
03-18-2009 02:44 PM
Hi John,
Sure and will do the same.
Thanks
Regards
Anantha Subramanian Natarajan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: