03-19-2009 06:58 AM - edited 03-04-2019 04:00 AM
Hi everybody,
Is it posible to bundle 2 Serial interfaces into a port-channel on a 2811 Router?
I know it can be done for Fastethernet interfaces, but don't know about Serial.
Please, any help is appreciated.
Thanks
03-19-2009 07:08 AM
Are you trying to achieve higher bandwidth? Did you consider using multilink?
03-19-2009 07:14 AM
That is correct.
Can you please elavorate a little more about using multilink.
03-19-2009 07:20 AM
PLease go to the following link for more details:
http://www.cisco.com/en/US/tech/tk713/tk507/technologies_configuration_example09186a0080112d31.shtml
Thanks,
Mohamad
03-19-2009 07:27 AM
Here is a sample config that might help.
Dave
interface Serial0/0/0:1
bandwidth 1536
no ip address
encapsulation ppp
ip route-cache flow
no fair-queue
no cdp enable
ppp chap hostname ******
ppp multilink
ppp multilink group 1
*
interface Serial0/0/1:1
bandwidth 1536
no ip address
encapsulation ppp
ip route-cache flow
no cdp enable
ppp chap hostname ******
ppp multilink
ppp multilink group 1
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: