cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
619
Views
8
Helpful
3
Replies

Question about portOperStatus.2.1 output

laamidd2003
Level 1
Level 1

MIB CISCO-STACK-MIB

Name portOperStatus.2.1

iso.org.dod.internet.private.enterprises.cisco.workgroup.ciscoStackMIB.portGrp.portTable.portEntry.portOperStatus.2.1

OID 1.3.6.1.4.1.9.5.1.4.1.1.6.2.1

Type INTEGER

Units

Access read-only

Status unknown

Value minorFault(3)

The current operational status of the port.

Possible Values :

down(-1)

other(1)

ok(2)

minorFault(3)

majorFault(4)

fullDuplex-10Mb(5)

fullDuplex-100Mb(6)

autoNego-failed(7)

halfDuplex-1000Mb(8)

fullDuplex-1000Mb(9)

Obviously some of these possible values are self explanatory.

But, what is a minor fault vs. a major fault?

Does ok mean everything is fine?

What does "other" mean?

Thanks,

Bob

3 Replies 3

Joe Clarke
Cisco Employee
Cisco Employee

A state of minorFault is not good. Check portAdditionalOperStatus for more of a clue as to why that may be.

Other could mean anything, really. It usually points to a gap between device and MIB instrumentation.

Ok, thanks.

On our 6513 Catalyst - IOS (tm) s72033_rp Software (s72033_rp-ADVIPSERVICESK9_WAN-M), Version 12.2(18)SXF7, RELEASE SOFTWARE (fc1)

portAdditionalOperStatus shows as an "unsupported OID"

This object is typically a CatOS object. You can try running "show int status" on the switch to see if that command gives you more specific details as to the real state of the port.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: