03-19-2009 12:51 PM - edited 03-15-2019 04:58 PM
We have a VG224 configured for MGCP and used for faxes. Our IP and analog phones are SCCP. We cannot call SCCP to MGCP, but can call MGCP (using a butt set off of the 66A block). Our partitions/CSSs are good. We can call MGCP to MGCP. Everything is G711. Is there some service or enterprise parameter that may not allow for these calls? Any ideas?
Solved! Go to Solution.
03-19-2009 02:21 PM
If you're on 12.4(20)T watch out for this bug: CSCsr87229
You can try changing the caller ID or doing a 'debug mgcp packet' to see if you see the unsupported caller ID length
-nick
03-19-2009 02:21 PM
If you're on 12.4(20)T watch out for this bug: CSCsr87229
You can try changing the caller ID or doing a 'debug mgcp packet' to see if you see the unsupported caller ID length
-nick
03-20-2009 06:11 AM
Nick! That was it! That is the second bug you identified for me on the same project. THANKS!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: