We have en existing Internet connection using our Cisco 3725 router (ISP A). The router does the NAT and here's the existing default route:
S* 0.0.0.0/0 [1/0] via 22.214.171.124
This router has a "16 Port 10BaseT/100BaseTX EtherSwitch".
Now we have a new Internet connection (ISP B). What I did was to configure two ports on the Etherswitch and added route maps:
description "ISP B to provider"
ip address 126.96.36.199 255.255.255.252
description "ISP B to my network"
ip address 188.8.131.52 255.255.255.248
ip policy route-map ISPBInternetTraffic
access-list 101 permit ip 184.108.40.206 0.0.0.7 any
route-map ISPBInternetTraffic permit 101
match ip address 101
set interface FastEthernet1/0
set ip default next-hop 220.127.116.11
What I want to happen is that when the router sees the traffic coming from the public IPs of ISP B (18.104.22.168 /29) it will direct that to go out ISP B on F1/0.
1. Is my configuration correct?
2. Any suggestions, recommendations?
3. Can I do load balancing or load sharing between the two ISPs?