MDS 9100 MGMT0 showing half duplex

Unanswered Question
Mar 23rd, 2009

My user has a Cisco MDS SAN module installed in a IBM Bladecenter chassis.

I took a look at the module's managment interface mgmt0. It's showing half duplex. The module does not allow me to change the duplex setting. According to documentation, duplex is auto sense.

The neighbor switch port is set for auto. It displayed "auto-full". I configured the switch port for full duplex. The mgmt0 interface still displayed as half duplex.

Anyone know of bug or issue with SAN mgmt0?

User has other modules same hardware and software version with no issue. We see full duplex on both sides.

sh version

Cisco Storage Area Networking Operating System (SAN-OS) Software

TAC support: http://www.cisco.com/tac

Copyright (c) 2002-2007, Cisco Systems, Inc. All rights reserved.

The copyrights to certain works contained herein are owned by

other third parties and are used and distributed under license.

Some parts of this software may be covered under the GNU Public

License or the GNU Lesser General Public License. A copy of

each such license is available at

http://www.gnu.org/licenses/gpl.html and

http://www.gnu.org/licenses/lgpl.html

Software

BIOS: version 1.0.12

kickstart: version 3.2(2c)

system: version 3.2(2c)

BIOS compile time: 09/10/07

kickstart image file is: bootflash:/m9100-s2ek9-kickstart-mz.3.2.2c.bin

kickstart compile time: 11/16/2007 12:00:00 [11/16/2007 23:23:43]

system image file is: bootflash:/m9100-s2ek9-mz.3.2.2c.bin

system compile time: 11/16/2007 12:00:00 [11/16/2007 23:49:32]

Hardware

cisco MDS IBM FC ("1/2/4 Gbps FC/Supervisor-2")

Motorola, ppc8541 (e500) with 515032 kB of memory.

Processor Board ID

bootflash: 250368 kB

B52EUP15-SAN2 kernel uptime is 234 days 13 hours 14 minute(s) 8 second(s)

Last reset at 636281 usecs after Fri Aug 1 08:20:47 2008

Reason: Feature NPV enabled

System version: 3.2(2c)

Service:

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Michael Brown Tue, 03/24/2009 - 02:57

You might want to check with IBM as to the difference in the Blade Center Chassis. There really is no physical interface for mgmt0 on the 9100, it is connected to the internal ethernet switch or hub via the back plane connectors. I believe that this switch or hub is on the Management Module for the chassis.

Are the Blade Center chassis the same model?

Could one chassis have a newer version of the Management Module that perhaps has a switch versus a hub incorporated?

Because there is no console port, the configuration of the management interface is disabled. It obtains all of it's settings from the Chassis. Disabling configuration on the mgmgt 0 interface prevents a situation where an incorrect setting disables the interface locking out the user. With an external MDS, you have the console as a way to recover if the mgmt 0 ends up with a configuration problem, as a way to recover.

Hope this helps,

Mike

Actions

This Discussion

 

 

Trending Topics: Storage Networking