Power to 521 Access Points

Unanswered Question
Mar 24th, 2009

I am trying to Power a Cisco 521 AP from a blade on a 4500 switch. The blade module number is WS-X4548-GB-RJ45V. This is supposed to be a POE blade, but when I plug the AP in, I do not get the AP to power up.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Leo Laohoo Tue, 03/24/2009 - 14:36

What is the IOS you are currently running? What is your Supervisor card?

Check the ports. See if "power inline never" is on the config.

Kevin Melton Tue, 03/24/2009 - 14:45

thanks for the response. It is actually configured for :power inline auto: on the port.

But it shows a status of :off:

Leo Laohoo Wed, 03/25/2009 - 15:48

Not familiar with this AP but are you sure you are plugging it into the FE port and not the console port?


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode