03-24-2009 08:58 AM - edited 07-03-2021 05:21 PM
I am trying to Power a Cisco 521 AP from a blade on a 4500 switch. The blade module number is WS-X4548-GB-RJ45V. This is supposed to be a POE blade, but when I plug the AP in, I do not get the AP to power up.
03-24-2009 02:36 PM
What is the IOS you are currently running? What is your Supervisor card?
Check the ports. See if "power inline never" is on the config.
03-24-2009 02:45 PM
thanks for the response. It is actually configured for :power inline auto: on the port.
But it shows a status of :off:
03-24-2009 02:59 PM
Check your cable.
03-25-2009 12:00 PM
I have tried using 2 different ethernet cables. Neither power up.
03-25-2009 03:48 PM
Not familiar with this AP but are you sure you are plugging it into the FE port and not the console port?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community
