please help Urgent !!!

Unanswered Question
Mar 24th, 2009

Cisco 7206VXR

==============

r1#show int g0/3

GigabitEthernet0/3 is down, line protocol is down

Hardware is MV64460 Internal MAC, address is 0021.a177.bc19 (bia 0021.a177.bc19)

Description: gi0/3--cs2-gi5/3

Internet address is x.x.x.

MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,

reliability 253/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Full-duplex, 1000Mb/s, link type is autonegotiation, media type is SX

output flow-control is XON, input flow-control is XON

ARP type: ARPA, ARP Timeout 04:00:00

Last input 02:58:01, output 02:58:01, output hang never

Last clearing of "show interface" counters 17w1d

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue: 0/40 (size/max)

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

6507438 packets input, 3948630701 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 watchdog, 0 multicast, 0 pause input

0 input packets with dribble condition detected

6411524 packets output, 2864443126 bytes, 0 underruns

13 output errors, 0 collisions, 12 interface resets

0 babbles, 0 late collision, 0 deferred

13 lost carrier, 0 no carrier, 0 pause output

0 output buffer failures, 0 output buffers swapped out

=========================================

cisco WS-C4510R

====================

sw#show int g5/3

GigabitEthernet5/3 is down, line protocol is down (notconnect)

Hardware is Gigabit Ethernet Port, address is 0012.8042.1f3f (bia 0012.8042.1f3f)

Description: gi5/3---gi0/3

Internet address is x.x.x.

MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Full-duplex, 1000Mb/s, link type is force-up, media type is 1000BaseSX

input flow-control is off, output flow-control is off

ARP type: ARPA, ARP Timeout 04:00:00

Last input 02:48:21, output never, output hang never

Last clearing of "show interface" counters 31w5d

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue: 0/40 (size/max)

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

L3 in Switched: ucast: 117755 pkt, 14932307 bytes - mcast: 0 pkt, 0 bytes

L3 out Switched: ucast: 56606 pkt, 11479071 bytes - mcast: 0 pkt, 0 bytes

8320414 packets input, 4144879380 bytes, 0 no buffer

Received 6353047 broadcasts (0 IP multicast)

152540 runts, 0 giants, 0 throttles

==================================

the interface g0/3 was on halg duplex I change it to full now the whole link is down ,, please save the night

Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
cisco steps Tue, 03/24/2009 - 23:53

Hi thanks for the quick response .. I did shut/ no shut and that did not work

Giuseppe Larosa Wed, 03/25/2009 - 01:40

Hello Ocporbust,

being a fiber based link it should be 1000 Mbps full always not configurable.

I don't understand why one side was telling it was half duplex.

I would try to remove all duplex commands but I suspect the gbic is not working well.

Edit:

being a GE port with two possible plugs

int gi0/3

no full duplex

media-type sfp

shut

no shut

Hope to help

Giuseppe

cisco steps Wed, 03/25/2009 - 11:26

Giuseppe the man in the house ,

We definitely have a bad GLC-SX (SFP)

Thanks again :-)

Actions

This Discussion