snmp-server enable traps syslog doesn't send all syslog messages in traps

MARK BARNHOORN · ‎03-25-2009

Below are the syslog/console messages and trap messages.

The DTP is logged, but the trap version of the syslog message is not. Any suggestions?

Cat 6500 (IOS 122-18.SXF7)

enterprises.9.9.41.1.2.3.1.5.41 = "Interface GigabitEthernet1/23, changed state to up"

enterprises.9.9.41.1.2.3.1.5.42 = "Line protocol on Interface GigabitEthernet1/23, changed state to up"

enterprises.9.9.41.1.2.3.1.5.43 = "Configured from console by mark onvty1 (10.3.144.22)"

%LINK-3-UPDOWN: Interface GigabitEthernet1/23, changed state to up

%LINK-SP-3-UPDOWN: Interface GigabitEthernet1/23, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/23, changed state to up

%LINEPROTO-SP-5-UPDOWN: Line protocol on Interface GigabitEthernet1/23, changed state to up

%DTP-SP-5-TRUNKPORTON: Port Gi1/23 has become dot1q trunk

%SYS-5-CONFIG_I: Configured from console by mark onvty1 (10.3.144.22)

Joe Clarke · ‎03-25-2009

This message is coming from the SP, and thus not sent as syslog traps. There is a feature request for this, CSCsf19672. Unfortunately, there is no ETA on an implementation.

MARK BARNHOORN · ‎04-01-2009

thanks for the feedback. Is that documented anywhere?

Joe Clarke · ‎04-01-2009

Just in the aforementioned bug as far as I've been able to tell.

MARK BARNHOORN · ‎04-01-2009

Hi Joe, OK. Thanks for the followup.