3750 Qos - mls qos queue-set

Unanswered Question
Mar 25th, 2009
User Badges:

Hi,


I have to configure below CLI to allocate % buffer to all queue and set thrreshold but i don't know what is number 1 & 2 CLI , does it have any purpose ? or i can use any number ?


3750G(config)#mls qos queue-set output ?

<1-2> queue-set id


REgards,

Chintan

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Yudong Wu Wed, 03/25/2009 - 09:00
User Badges:
  • Gold, 750 points or more

You can configure two sets of Qos queue parameters. Queue-set 1 and 2 are just two different sets of Qos queue parameter. By default, port will use queue-set 1. You can change it by "queue-set #" command under the interface.


chintan-shah Wed, 03/25/2009 - 09:35
User Badges:

Thanks, you mean i can change buffer value using default queue-set for all queue and no need to use queue-set 2.


Which scenario require to use both queue-set ?



Yudong Wu Wed, 03/25/2009 - 09:47
User Badges:
  • Gold, 750 points or more

sure you can.

For example, if you want some of the ports in switch use certain qos queue parameter and the others use a different one for some reasons.

ccardon Fri, 04/24/2009 - 03:02
User Badges:

Hej Chintan,


You could for example assign "queue-set 1" to all of your user port and "queue-set 2" to the backbone trunk port.


int f0/1

description USER

queue-set 1


int g0/1

description UPLINK TO BACKBONE

queue-set 2


chintan-shah Thu, 04/30/2009 - 23:11
User Badges:

Thanks for further clarification. I am going to use same way now.



Actions

This Discussion