03-25-2009 06:58 AM - edited 03-06-2019 04:48 AM
Hi,
I have to configure below CLI to allocate % buffer to all queue and set thrreshold but i don't know what is number 1 & 2 CLI , does it have any purpose ? or i can use any number ?
3750G(config)#mls qos queue-set output ?
<1-2> queue-set id
REgards,
Chintan
03-25-2009 09:00 AM
You can configure two sets of Qos queue parameters. Queue-set 1 and 2 are just two different sets of Qos queue parameter. By default, port will use queue-set 1. You can change it by "queue-set #" command under the interface.
03-25-2009 09:35 AM
Thanks, you mean i can change buffer value using default queue-set for all queue and no need to use queue-set 2.
Which scenario require to use both queue-set ?
03-25-2009 09:47 AM
sure you can.
For example, if you want some of the ports in switch use certain qos queue parameter and the others use a different one for some reasons.
03-25-2009 08:15 PM
Thanks, I got it.
Many thanks for help !!
Chintan
04-24-2009 03:02 AM
Hej Chintan,
You could for example assign "queue-set 1" to all of your user port and "queue-set 2" to the backbone trunk port.
int f0/1
description USER
queue-set 1
int g0/1
description UPLINK TO BACKBONE
queue-set 2
04-30-2009 11:11 PM
Thanks for further clarification. I am going to use same way now.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: