03-25-2009 03:16 PM - edited 03-11-2019 08:10 AM
Hello,
I've just installed a new 100mb nic card, Part is "Cisco PIX-1FE and when the pix boots up, it seems to recognize it but says it's disabled.
Anyone know how to enable the new interface?
-----------------------------------------------------------------------
Cisco PIX Firewall
Cisco PIX Firewall Version 6.3(5)
Licensed Features:
Failover: Disabled
VPN-DES: Enabled
VPN-3DES-AES: Disabled
Maximum Physical Interfaces: 3
Maximum Interfaces: 5
Cut-through Proxy: Enabled
Guards: Enabled
URL-filtering: Enabled
Inside Hosts: Unlimited
Throughput: Unlimited
IKE peers: Unlimited
This PIX has a Restricted (R) license.
Additional 1 interface(s) is(are) disabled
Looks like I might need to buy the license for it? Is that correct?
Solved! Go to Solution.
03-25-2009 03:34 PM
Then you need unrestricted license or you could look at using 802.1q on one of your interfaces and have subinterfaces ie. note that maximum physical interfaces = 3 but maximum interfaces = 5.
Jon
03-25-2009 03:18 PM
Does the new card take the physical number of interfaces to 4 ?
If so then yes you need to get an unrestricted license.
Jon
03-25-2009 03:20 PM
Yes, it takes it up to 4 physical interfaces now..
03-25-2009 03:34 PM
Then you need unrestricted license or you could look at using 802.1q on one of your interfaces and have subinterfaces ie. note that maximum physical interfaces = 3 but maximum interfaces = 5.
Jon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide