Solved: Ð¡Ð¡Ðœ 6.1 and ATA 186 - Cisco Community

243

Views

0

Helpful

1

Replies

Hi. I have ccm 6.1 and ata 168. The analog phone in 1 port work very good, but analog phone in 2 port work only into my network. Other device connected in 2 port do not work. I can not make a call to the city, or transfer the call to the phone connected to port 2.

You can help me resolve this problem?

1 Accepted Solution

Accepted Solutions

Hi Slava,

Just a thought here, but the second port of an ATA only supports g.711. This is what usually throws a wrench into the thought process here;

Have a look at these two good posts that relate to this type of issue;

From Paul @ Cisco;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=General&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddc9467/3#selected_message

From Jan;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddf3e5c/4#selected_message

Hope this helps!

Rob

View solution in original post

1 Reply 1

Hi Slava,

Just a thought here, but the second port of an ATA only supports g.711. This is what usually throws a wrench into the thought process here;

Have a look at these two good posts that relate to this type of issue;

From Paul @ Cisco;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=General&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddc9467/3#selected_message

From Jan;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddf3e5c/4#selected_message

Hope this helps!

Rob