AP1252 point to multipoint connection

Unanswered Question
Mar 26th, 2009
User Badges:

Is it possible to make with a 1252 a multipoint to point connection, on central building that connect two different buildings, and what about the antenna connections, there are three connections but is it possible to connect 2 antennas one for one building and the other for the other building ?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
tstanik Wed, 04/01/2009 - 15:09
User Badges:
  • Bronze, 100 points or more

On bridges set up in a point-to-point configuration, set the RTS threshold to 4000 on both the root and non-root bridges. If you have multiple bridges set up in a point-to-multipoint configuration, set the RTS threshold to 4000 on the root bridge and to 0 on the non-root bridges.


Examples

This example shows how to set the RTS threshold on a bridge to 4000 bytes:

bridge(config-if)# rts threshold 4000

This example shows how to set the RTS retries count to 3:

AP(config-if)# rts retries 3

This example shows how to reset the parameter to defaults:

AP(config-if)# no rts

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode