Edison Ortiz Thu, 03/26/2009 - 12:20
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

write erase

then

delete flash:vlan.dat


(reboot).


__


Edison.

sivaprakasam81 Thu, 03/26/2009 - 12:29
User Badges:

Okay. I will do that and update the same. For reload, can i use 'reload' command from CLI or Is there any reset switch on the hardware switch to reboot the switch to factory default?


Thank you,

Edison Ortiz Thu, 03/26/2009 - 12:31
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

Okay. I will do that and update the same. For reload, can i use 'reload' command from CLI


Yes.

sivaprakasam81 Thu, 03/26/2009 - 12:36
User Badges:

Thank you very much!Is there any pre-cuastion need to check before the reload to avoid boot failure or ROMmode.


Like, Boot image verification, path?

Edison Ortiz Thu, 03/26/2009 - 12:37
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

It's always wise to check you have a valid image in the flash before rebooting. I suggest rebooting before the 'write erase' procedure and make sure it works.


__


Edison.

Edison Ortiz Thu, 03/26/2009 - 12:50
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

dir /all

or

show flash:


__


Edison.

sanmigueelbeer Thu, 03/26/2009 - 14:41
User Badges:

Aside from Edison's comment, during the bootup sequence make sure you keep a close eye for any error messages.


When the bootup sequence has completed, you have the option to do the following:


Enter into enable mode and type "sh post". If the system is OK, it should respond with "Pass".

Actions

This Discussion