CUCM 7 Service provider SIP

Answered Question
Mar 26th, 2009
User Badges:

We are integrating a CUCM 7 to a service provider SIP trunk for basically calling out but I can not find where to place the user/pass that the carrier ask for.

Do I have to use forcibly a Gateway? or is there a guide?

Correct Answer by Nicholas Matthews about 8 years 1 month ago

CUCM does not support registering numbers to a SIP provider.


You may want to look into CUBE for this feature.



-nick

Correct Answer by mattcalderon about 8 years 1 month ago

There is no entry for a username/pass configuration on the CUCM and will require the use of a IPtoIP gateway or CUBE as it's commonly known as.


http://www.cisco.com/en/US/products/sw/voicesw/ps5640/products_configuration_example09186a00808ead0f.shtml


You would be entering your credentials under the sip-au configuration mode on the gateway.


Matt


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (2 ratings)
Loading.
Correct Answer
mattcalderon Thu, 03/26/2009 - 13:10
User Badges:
  • Silver, 250 points or more

There is no entry for a username/pass configuration on the CUCM and will require the use of a IPtoIP gateway or CUBE as it's commonly known as.


http://www.cisco.com/en/US/products/sw/voicesw/ps5640/products_configuration_example09186a00808ead0f.shtml


You would be entering your credentials under the sip-au configuration mode on the gateway.


Matt


Correct Answer
Nicholas Matthews Thu, 03/26/2009 - 13:48
User Badges:
  • Red, 2250 points or more

CUCM does not support registering numbers to a SIP provider.


You may want to look into CUBE for this feature.



-nick

Actions

This Discussion