cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
349
Views
5
Helpful
5
Replies

Static NAT problem

John Blakley
VIP Alumni
VIP Alumni

All,

I have a problem in that I have multiple IP addresses that get redirected to the same internal host.....on the same port.

I can't do:

static (dmz1,outside) x.x.x.x x.x.x.x netmask x.x.x.x

And I can't do:

static (dmz1,outside) tcp x.x.x.x port x.x.x.x port netmask 255.255.255.255

Can I do anything for this?

Thanks,

John

HTH, John *** Please rate all useful posts ***
1 Accepted Solution
5 Replies 5

Jon Marshall
Hall of Fame
Hall of Fame

John

I don't think you can do this with the ASA. If the source addresses were different depending on the public IP address being accessed then you could do something but if this isn't the case i don't think the ASA will let you configure this.

Jon

Vikram

Many thanks for this. I was involved in that post too so i should have remembered :-)

John

Apologies, totally forgot about that post, your memory goes as you get older :-).

Jon

no worries JON, we all make mistakes :).

Jon,

I submitted a tac case yesterday, and they said that it was impossible.

I just tested this on my ASA at the house, and it works great. =)

Thanks Jon and Vikram!

John

HTH, John *** Please rate all useful posts ***
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: