Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1048
Views
0
Helpful
2
Replies

PIX 506 Wont boot, power and ACT LED off, Network LED Flashing

dstanek57
Level 1
Level 1

‎03-27-2009 08:15 PM - edited ‎03-11-2019 08:11 AM

Hi

I have a PIX 506 (not 506e) with OS 6.3.3. It stopped working today and I tried reseating all cables and powering back up. All that happens is the Network LED flashing and the Power and ACT LED's are off. The fan comes on immediatley. I have not hooked to the console with a laptop yet. When I turn the power button on the back all 3 LED's flicker but only the Network LED remains lit while the other two remain off. I have reseated the memory and nothing else. It is plugged into a UPS. Any ideas as I am no expert and need help bad.

thanks doug

Labels:
0 Helpful
2 Replies 2

Yudong Wu
Level 7
Level 7

‎03-29-2009 12:14 AM

can u connect the console and capture its output when you power cycle it? It might be a bad hw.

0 Helpful

dstanek57
Level 1
Level 1
In response to Yudong Wu

‎03-29-2009 07:50 AM

Hello

this has ben resolved it turned out to be a funky actiing external power supply. changed that and all came back fine. Heard the power supply on the 506 are notorious for this after a few years of service.

thanks doug

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card