I have 3560s that are configured with vlans 1,2,22. I have a CE520 connected to port 22 of one of the Catalyst 3560s. The port is configured trunking. I want to plug a phone into the CE520 and operate on vlan 22.
How do I get the vlans from the catalyst 3560s to propogate to the CE520?
Right now the CE gigabit uplink port is configured as default vlan 1. When I plug my laptop into port 1 of the CE520, I get an IP Address from Vlan 1 and I can get to the internet fine. However, when I plug an IP 7940 IP Phone into port two, it does not get an ip address from vlan 22.
Any assistance on this would be greatly appreciated.
You can create vlan 22 on CE520. It won't impact cat3550.
Basically, on 3550 side, port f0/22 is a trunk port and permit all vlans. Vlan 22 is configure as voice vlan.
Personally, I did not use CE520 before. I know it does not have CLI and have to config it via CCA.