Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
435
Views
0
Helpful
1
Replies

Interface Dot11Radio0, failed - cmd busy -Traceback.....

sqrbncisco
Level 1
Level 1

‎03-30-2009 12:15 AM - edited ‎07-03-2021 05:22 PM

hi everyone,

please help me,

i have a problem with cisco autonomous:

Product/Model Number: AIR-AP1131AG-E-K9 System Software Filename: c1130-k9w7-tar.124-10b.JA System Software Version: 12.4(10b)JA Bootloader Version: 12.3(8)JEA

the problem is that my autonomous cisco AP sometimes crash and the only way to overcome this is to reset the AP...

i found the log --> "Interface Dot11Radio0, failed - cmd busy -Traceback= 0x5DBF8 0x4EDE70 0x4EDDD4 0x797684 0x7978E4 0x79BD64 0x4ECEC8 0x4ED2D0 0x4ED684 0x198850"

any comment on this problem....

please advice....

thanks

Labels:
0 Helpful
1 Reply 1

Leo Laohoo
Hall of Fame
Hall of Fame

‎03-30-2009 02:45 AM

In enable mode, can you do a "dir flash:" and post the contents?

Do a "show ip interface brief" and make sure your radios are still up/up.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card