VirtualTemplate palaver

Unanswered Question
Mar 30th, 2009

Hello All,

I created two V-templs on R1 pointing to R3 and R4 as shown here:

R1

interface Virtual-Template13

interface Virtual-Template14

R3

interface Virtual-Template31

R4

interface Virtual-Template41

And as a result of this, two virtual-Access was cteated on R1 as one would expect in the "sh ip int brief" and were in the up states BUT the virtual-template itselves remained in the down state.

Because of this the desired results could not be achieved, how then can i bring these virtual-template interfaces to up up states?

Thanking you all in advance

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
pkurdziel Mon, 03/30/2009 - 18:59

The virtual-templates will always show down/down because they are just templates.

newnetman Mon, 03/30/2009 - 19:52

Hello,

Thanks for your response to my query.

The virtual-Access is actually in up/up states, But if that is what is expected how come my desired result could not be achieved?.

The intention was to send a summary routes and a specific route ro R3 while R4 should receive only the summary routes.

can you help further please?

Thank you

Actions

This Discussion