cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
326
Views
0
Helpful
3
Replies

VirtualTemplate palaver

newnetman
Level 1
Level 1

Hello All,

I created two V-templs on R1 pointing to R3 and R4 as shown here:

R1

interface Virtual-Template13

interface Virtual-Template14

R3

interface Virtual-Template31

R4

interface Virtual-Template41

And as a result of this, two virtual-Access was cteated on R1 as one would expect in the "sh ip int brief" and were in the up states BUT the virtual-template itselves remained in the down state.

Because of this the desired results could not be achieved, how then can i bring these virtual-template interfaces to up up states?

Thanking you all in advance

3 Replies 3

Peter010101
Level 1
Level 1

The virtual-templates will always show down/down because they are just templates.

Virtual-Access should show up/up.

Hello,

Thanks for your response to my query.

The virtual-Access is actually in up/up states, But if that is what is expected how come my desired result could not be achieved?.

The intention was to send a summary routes and a specific route ro R3 while R4 should receive only the summary routes.

can you help further please?

Thank you

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: