03-30-2009 05:51 PM - edited 03-04-2019 04:09 AM
Hello All,
I created two V-templs on R1 pointing to R3 and R4 as shown here:
R1
interface Virtual-Template13
interface Virtual-Template14
R3
interface Virtual-Template31
R4
interface Virtual-Template41
And as a result of this, two virtual-Access was cteated on R1 as one would expect in the "sh ip int brief" and were in the up states BUT the virtual-template itselves remained in the down state.
Because of this the desired results could not be achieved, how then can i bring these virtual-template interfaces to up up states?
Thanking you all in advance
03-30-2009 06:59 PM
The virtual-templates will always show down/down because they are just templates.
03-30-2009 07:00 PM
Virtual-Access should show up/up.
03-30-2009 07:52 PM
Hello,
Thanks for your response to my query.
The virtual-Access is actually in up/up states, But if that is what is expected how come my desired result could not be achieved?.
The intention was to send a summary routes and a specific route ro R3 while R4 should receive only the summary routes.
can you help further please?
Thank you
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: