03-31-2009 01:38 AM - edited 03-04-2019 04:10 AM
Hi,
I have a trouble with any Cisco 1721 ( I have tried with three cisco 1721) that I connect to two lines. I have installed a WIC 1SHDSL and a WIC 1ADSL. The SHDSL is a 2 Mb symmetric dedicated line, the ADSL is a 2048/320 standar, ULL, ETH.
I have tested the equipments with other lines and I do not have any problem. I have ruled out electrical problems.
The error that we can see after the restart is: "System returned to ROM by address error at PC 0x8000EC38, address 0x8000EC38".
The router can work 5 consecutive days and it can restart every 30 minutes during 2 consecutive days.
"sh ver" shows:
ios y más: Cisco IOS Software, C1700 Software (C1700-ADVSECURITYK9-M), Version 12.4(21a), RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2008 by Cisco Systems, Inc.
Compiled Mon 29-Sep-08 13:38 by prod_rel_team
ROM: System Bootstrap, Version 12.2(7r)XM2, RELEASE SOFTWARE (fc1)
I will try with 1800 series.
Let me know if you need more information,
Thanks.
03-31-2009 03:57 AM
Can you post your crashinfo file? A Traceback is normally synonymous to RMA.
04-01-2009 12:32 AM
04-01-2009 04:14 PM
Hi Ricardo,
Unfortunately, this is not the crashinfo file. If you do a "dir flash:", do you see a file called "crashinfo"?
04-02-2009 12:58 AM
04-02-2009 02:23 AM
Hi Ricardo,
I've just checked your crashinfo files. The error message "NAT: WARNING: STATIC entry removes NOT from CLI" is the last message before your router goes into a spasm.
I think you need to post your config. Something is your cnfig is forcing the IOS and hardware to disagree on something.
04-02-2009 03:41 AM
05-06-2009 06:49 AM
There are the same problems with Cisco 1841. I have tried with WIC-SHDSL and WIC-SHDSL-V3 without success.
05-06-2009 07:13 AM
Have you tried swapping the memory out? It might be caused by corrupted memory and when the NAT or routing tables gets too big, it hits the corrupted memory sector and causes the reboot.
05-07-2009 12:34 AM
Hi,
I have tried with deferent equipments ( Three 1721 and one 1841). They have different memory modules. I have connected Draytek Vigor 3100 and the line is working perfectly but I can't keep it eternally because I need a backup solution.
05-06-2009 07:13 AM
05-06-2009 07:14 AM
05-06-2009 07:14 AM
05-06-2009 07:19 AM
05-06-2009 07:21 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: