CME Directory Lookup For Inbound SIP Calls

Unanswered Question
Mar 31st, 2009

Greetings, i have a Cisco 2811 ISR running CME v7.0. I know this may sound like a straight forward question but it's one ive never been able to get working properly.

I would like to configure the local directory with customer and supplier numbers so that when an inbound call is placed from our SIP provider the name is displayed instead of the calling number.

Calls between SCCP enabled handsets display the calling name just fine.

I have the following commands in the config already.

service dnis dir-lookup

service dnis overlay

url directories

directory entry 1 07*******10 name Test Mobile Number

I have tried the "no service local-directory" an using local speed dials but to no avail.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 1 (1 ratings)
ivillegas Tue, 04/07/2009 - 07:42

Post the following for a call made from SIP phone:

show version

show run

show telephony-service

debug ccsip all

no debug ccsip transport


This Discussion