NetFlow

Unanswered Question
Mar 31st, 2009
User Badges:

Is it enought on Catalyst 4500 enable NetFlow Globally (of course IP routing is enabled from before) with command:


Switch# configure terminal

Switch(config)# ip route-cache flow


or


does it needs enable aggregation configuration


and


what is difference between:


. Autonomous System Configuration


*Destination Prefix Configuration


*Prefix Configuration


*Protocol Port Configuration


*Source Prefix Configuration


regards,

davor

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
drolemc Mon, 04/06/2009 - 13:35
User Badges:
  • Silver, 250 points or more

To enable NetFlow (ingress) accounting for traffic arriving on an interface, use the

ip route-cache flow command in interface configuration mode.

Actions

This Discussion