WAN router with failover to external VPN device

Answered Question

Cisco 2811 with MPLS running RIPv2. What is the best way to configure VPN failover to another device (Juniper SSG-350) that is on the same LAN? Is this as simple as weighted static route?

Correct Answer by thotsaphon about 8 years 2 months ago

Chip,

It was my typo again. It should be look like this:

ip route 20.0.0.0 255.0.0.0 10.100.100.1(Juniper) 130(AD)


HTH,

Toshi

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
thotsaphon Tue, 03/31/2009 - 13:19
User Badges:
  • Gold, 750 points or more

Chip,

Just add static routes pointing to Juniper with higher AD than RIP. This should be fine.


HTH,

Toshi

Correct Answer
thotsaphon Tue, 03/31/2009 - 13:27
User Badges:
  • Gold, 750 points or more

Chip,

It was my typo again. It should be look like this:

ip route 20.0.0.0 255.0.0.0 10.100.100.1(Juniper) 130(AD)


HTH,

Toshi

Actions

This Discussion