03-31-2009 01:29 PM - edited 03-06-2019 04:55 AM
Hi,
Facing issue in Cisco 6509 switch with the port speed and duplex servers are not negotiating on 1 Gbps but it is working on 100 Mbps.
We have tried by making combination of Auto / 1000 Full Duplex on both switch and server side but still it is not working.
Logs are attached
03-31-2009 01:45 PM
Rakesh,
Are all servers connecting with 100Mbps?
You did hard code on both ends. Still not working. It sounds a bit crazy but what is the media type you are using? Cat5?
Toshi
03-31-2009 02:01 PM
Check the wiring , you need 4 good pairs all the way thru to the servers as gig uses all 8 wires to run. 1 bad wire or pair will not allow gig service.
03-31-2009 02:11 PM
In addition to glen check whether the server NIC drivers are upto date
Have seem some problems due to them in the past
Narayan
03-31-2009 03:09 PM
Are you sure the server's NIC will go 1Gb???
Can you post what is the NIC's model number?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: