cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
645
Views
0
Helpful
9
Replies

CUCME Version 7.0(1) GUI Problem

cristian.munoz
Level 4
Level 4

Hi, I can't access to CUCME by GUI. When I put the username and the pass, then, the web page get to blank.

The commands web admin system name admin password cisco and ip http server are run.

Regards

1 Accepted Solution

Accepted Solutions

Hello,

Please verify that you have the following files on your flash:

Admin-user.html

Admin_user.js

CiscoLogo.gif

delete.gif

dom.js

downarrow.gif

ephone_admin.html

logohome.gif

normal_user.html

normal_user.js

Plus.gif

sxiconad.gif

Tab.gif

Telephony_service.html

uparrow.gif

xml.template

xml-test.html

These are all of the files necessary to enable full GUI functionality.

Hope that helped, if so please rate.

View solution in original post

9 Replies 9

Hello,

Do you have "ip http path flash:" configured?

Dear Kenneth...Yes

Hi to access the GUI and allow the admin to add remove DNs from web interface:

ip http server

ip http path flash:

telephony-service

web admin system name admin password cisco

dn-webedit

time-webedit

Hope this help

David

Cool, I'm going to re-configure and I will show you the result.

Hi..fail. :(. I think that upgrading will be fine.

Hi David

I upgraded to 124-22.T (Cisco 2811), but i still can't access to GUI. I put the user and passw and then it show me the page in blank. Pls.,see the command

ip http server

ip http authentication local

ip http secure-server

ip http timeout-policy idle 60 life 86400 requests 10000

ip http path flash:

telephony-service

em logout 0:0 0:0 0:0

max-ephones 42

max-dn 80

ip source-address 10.175.206.1 port 2000

system message CME

user-locale ES

network-locale ES

time-zone 18

time-format 24

date-format dd-mm-yy

voicemail 3120

max-conferences 8 gain -6

web admin system name admin password cisco

dn-webedit

time-webedit

transfer-system full-consult

create cnf-files version-stamp 7960 Mar 31 2009 15:20:31

I don't know what happens

Hello,

Please verify that you have the following files on your flash:

Admin-user.html

Admin_user.js

CiscoLogo.gif

delete.gif

dom.js

downarrow.gif

ephone_admin.html

logohome.gif

normal_user.html

normal_user.js

Plus.gif

sxiconad.gif

Tab.gif

Telephony_service.html

uparrow.gif

xml.template

xml-test.html

These are all of the files necessary to enable full GUI functionality.

Hope that helped, if so please rate.

Dear Kenneth, the problem is solved.

Thanks a lot!!

Hi All,

i have CME version 7.1 with IOS 12.4(24T1)and i experienced the same problem with the GUI interface. i found that the problem came from copying the GUI files using a flash reader, when i uploaded the files using the archive command and used the command ip http server path flash: ,the GUI worked fine but after a restart.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: