04-01-2009 09:33 AM - edited 03-04-2019 04:11 AM
I'm trying to setup a test bed for callmanager 7 and the router I'm using for the network will not recognize any of the voice cards in the running config (as in, no dial-peers or voice ports.) I am running it's default IOS 12.4(3g) SPServices which we are using elsewhere just fine. I issue the "sh ver" command and I see that it recognizes that I have a 4 port FXO, 2-port FXS and a Channelized T1/PRI Controller card plugged in.
Sh Ver:
Cisco 2811 (revision 53.51) with 251904K/10240K bytes of memory.
Processor board ID FTX1233A42P
2 FastEthernet interfaces
1 Serial interface
1 Channelized T1/PRI port
4 Voice FXO interfaces
2 Voice FXS interfaces
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
62720K bytes of ATA CompactFlash (Read/Write)
Any ideas would be greatly appreciated!
04-01-2009 09:36 AM
Justin,
Please post a "sh diag" command.
To make sure that you have any PVDM installed on it.
Toshi
04-01-2009 10:18 AM
Test_Router#sh diag
Slot 0:
C2811 Motherboard with 2FE and integrated VPN Port adapter, 2 ports
Port adapter is analyzed
Port adapter insertion time unknown
EEPROM contents at hardware discovery:
PCB Serial Number : FOC12312FZM
Hardware Revision : 1.0
Top Assy. Part Number : 800-26920-04
Board Revision : A0
Deviation Number : 0
Fab Version : 04
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Processor type : 87
Hardware date code : 20080731
Chassis Serial Number : FTX1233A42P
Chassis MAC Address : 0022.904c.9748
MAC Address block size : 24
CLEI Code : COM7R00ARA
Product (FRU) Number : CISCO2811
Part Number : 73-10258-05
Version Identifier : V05
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF C1 8B 46 4F 43 31 32 33 31 32 46 5A 4D 40
0x10: 03 E7 41 01 00 C0 46 03 20 00 69 28 04 42 41 30
0x20: 88 00 00 00 00 02 04 03 00 81 00 00 00 00 04 00
0x30: 09 87 83 01 32 68 5B C2 8B 46 54 58 31 32 33 33
0x40: 41 34 32 50 C3 06 00 22 90 4C 97 48 43 00 18 C6
0x50: 8A 43 4F 4D 37 52 30 30 41 52 41 CB 8F 43 49 53
0x60: 43 4F 32 38 31 31 20 20 20 20 20 20 82 49 28 12
0x70: 05 89 56 30 35 20 D9 02 40 C1 FF FF FF FF FF FF
WIC Slot 0:
2nd generation - FXS Voice daughter card (2 port)
Hardware Revision : 3.1
Top Assy. Part Number : 800-21341-01
Board Revision : E0
Deviation Number : 0-0
Fab Version : 01
PCB Serial Number : FOC093352D2
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Version Identifier : V
Product (FRU) Number : VIC2-2FXS=
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF 40 00 47 41 03 01 C0 46 03 20 00 53 5D 01
0x10: 42 45 30 80 00 00 00 00 02 01 C1 8B 46 4F 43 30
0x20: 39 33 33 35 32 44 32 03 00 81 00 00 00 00 04 00
0x30: 89 56 00 00 00 FF FF FF FF FF FF FF FF FF FF FF
0x40: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
WIC Slot 1:
2nd generation - FXO Voice daughter card (4 port)
Hardware Revision : 5.0
Top Assy. Part Number : 800-21589-02
Board Revision : A0
Deviation Number : 0-0
Fab Version : 04
PCB Serial Number : FOC10440M4U
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Product (FRU) Number : VIC2-4FXO
Version Identifier : V01
CLEI Code : CNUIAPRAAA
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF 40 00 4C 41 05 00 C0 46 03 20 00 54 55 02
0x10: 42 41 30 80 00 00 00 00 02 04 C1 8B 46 4F 43 31
0x20: 30 34 34 30 4D 34 55 03 00 81 00 00 00 00 04 00
0x30: CB 89 56 49 43 32 2D 34 46 58 4F 89 56 30 31 20
0x40: C6 8A 43 4E 55 49 41 50 52 41 41 41 FF FF FF FF
0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
04-01-2009 10:18 AM
WIC Slot 2:
FT1 PMC4351
Hardware Revision : 1.2
PCB Serial Number : FOC10505GXJ
Part Number : 73-8346-05
Board Revision : A0
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Deviation Number : 0-0
Product (FRU) Number : WIC-1DSU-T1-V2
Top Assy. Part Number : 800-22193-03
CLEI Code : IPUIAPRRAA
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF 40 00 52 41 01 02 C1 8B 46 4F 43 31 30 35
0x10: 30 35 47 58 4A 82 49 20 9A 05 42 41 30 03 00 81
0x20: 00 00 00 00 04 00 80 00 00 00 00 CB 94 57 49 43
0x30: 2D 31 44 53 55 2D 54 31 2D 56 32 20 20 20 20 20
0x40: 20 C0 46 03 20 00 56 B1 03 C6 8A 49 50 55 49 41
0x50: 50 52 52 41 41 FF FF FF FF FF FF FF FF FF FF FF
0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
WIC Slot 3:
T1 (1 port) Multi-Flex Trunk WAN daughter card
Hardware revision 1.0 Board revision D0
Serial number 30264715 Part number 800-03568-03
FRU Part Number VWIC-1MFT-T1=
Test history 0x0 RMA number 00-00-00
Connector type PCI
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 20 01 00 01 CD CD 8B 50 0D F0 03 00 00 00 00
0x30: 68 00 00 00 03 04 01 00 FF FF FF FF FF FF FF FF
04-01-2009 10:28 AM
Justin,
You need PVDM installed on it.
Do you have a CCO ID? If you do, please check this link.
http://www.cisco.com/cgi-bin/Support/DSP/cisco_prodsel.pl
HTH,
Toshi
04-01-2009 10:37 AM
I feel partially dumb, ha. Thanks for your help.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: