RV082 Load Balanced - user mapped to specific wan port

Unanswered Question
Apr 1st, 2009
User Badges:

I have an RV082 setup with a balanced dual circuit. One of my clients needs to have their system use only one WAN port for security verification at the other end. How or can this be done?? IE map internal IP to use only 1 WAN port (thereby only one visible ext IP)

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jon Marshall Wed, 04/01/2009 - 12:57
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Policy Based Routing sounds like it may meet your requirements ie.


access-list 101 permit ip host any


route-map PBROUT permit 10

match ip address 101

set ip next-hop


then on the interface that packets from internal IP arrive on


int fa0/0

ip policy route-map PBROUT


Jon

Actions

This Discussion