Kenneth Mohammed Wed, 04/01/2009 - 23:54
User Badges:
  • Silver, 250 points or more

Hello,


Basically, you would just configure the vg224 as an h323 gateway, and have voip dial-peers on the CME pointing to the extensions on the VG224, pots dial-peers on the VG224 pointing to the specific port that the extension is on, and voip dial-peers on the VG224 pointing to the CME to facilitate outbound calling. Example


On the CME:


dial-peer voice 5000 voip

description VG224 Analog Phones

destination-pattern 500[0-9]

session target ipv4:[ip of vg224]

dtmf-relay h245-alphanumeric



On the VG224


dial-peer voice 5000 pots

destination-pattern 5000

port 2/0


dial-peer voice 5001 pots

destination-pattern 5001

port 2/1


dial-peer voice 5002 pots

destination-pattern 5002

port 2/2


etc, etc.


For outbound dialing from the analog phones:


dial-peer voice 9 voip

description Outbound Calling

destination-pattern [insert outbound calling pattern]

session target ipv4:[ip address of CME router]

dtmf-relay h245-alphanumeric


Hope that helped, if so please rate.

tabrez_shaikh Wed, 04/08/2009 - 22:04
User Badges:

Thanks for you suggesstion but now i cannot get Caller ID when dialing from my analog Phone , I am using E1 Link Need you valuable comment on this


Regards

TAB

Paolo Bevilacqua Wed, 04/08/2009 - 23:32
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

I do not recommend configuring the VG224 as H.323 GW. What you most likely want to so, is to configure it in SCCP mode. That will let you configure the analog phones just like ephones, with the full set of features.

tabrez_shaikh Sun, 04/12/2009 - 03:11
User Badges:

Dear


What if i need to put a FAX instead of phone and can you pls help me to configure in SCCP mode

tabrez_shaikh Wed, 04/15/2009 - 23:06
User Badges:

Dear


Can you please guide me with the SCCP configuration


Thanks in Advance


Regards


Actions

This Discussion