how to make a route feasible successor

Unanswered Question
Apr 2nd, 2009

Hi all, I have 2 switches connected , by 2 different l3 interfaces, so they are both successors and load balancing, how would I make one of the routes to become feasible successor? the interfaces are normal fastethernet.

cheers

Carl

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Giuseppe Larosa Thu, 04/02/2009 - 05:41

Hello Carl,

if you want to make one link less preferred then the other one

check current delay with

sh int fx/y

then use

int fx/y

delay xxx

use a greater value then the default one.

method2:

more selective using offset-list applied under router eigrp process

http://www.cisco.com/en/US/docs/ios/iproute/configuration/guide/irp_cfg_eigrp_ps6350_TSD_Products_Configuration_Guide_Chapter.html#wp1054179

using this you can make one path less preferred only for specific route(s)

Hope to help

Giuseppe

carl_townshend Fri, 04/03/2009 - 02:26

how would I make it feasible successor? i changed the delay to higher, but its still showing as successor.

any ideas ?

Giuseppe Larosa Fri, 04/03/2009 - 03:24

Hello Carl,

may you post

sh ip eigrp topology

! let me use placeholders names for the

! two lan interfaces

sh int f0/0

sh int f0/1

sh ip eigrp int f0/0

sh ip eigrp int f0/1

all of these commands on the local router that sees the two equal cost paths

Hope to help

Giuseppe

Actions

This Discussion