Configuring NetFlow and Dynamic Vulnerability Scanning

Unanswered Question
Apr 2nd, 2009

Hi All,

Configuring of NetFlow and Vulnerability Scanning are done.Where and how to check the netflow and Vulnerabilty scanning?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
sbilgi Wed, 04/08/2009 - 15:08

After enabling network scanning, you can view individual scan reports from Device Management > Clean Access > Network Scanner > Reports. The report shown here is the full administrator report (Figure 13-13). The report shown to end users contains only the vulnerability results for the enabled plugins. (Users can access their version of the scan report by clicking the Scan Report link in their Logout page.)

for more information follow up on this link:

CSCO10320953 Mon, 04/20/2009 - 19:15

Hi ,

I am talking about CSmars configuration but your answer seems NAC configuration.Would u confirm which is related to CS mars or NAC.


This Discussion