Initiate test outbound call from Cube router

Unanswered Question
Apr 2nd, 2009
User Badges:

Can you initiate a test outbound call from the IP2IP Gateway router terminating a SIP trunk?


I just need to initiate a call outbound onto the SIP trunk, it doesn't matter if the other end answers.


We have a failover scenario and I need to initiate a call from one site, then the other for testing prior to having this in our production.


I would like to initiate it from the router.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Brandon Buffin Thu, 04/02/2009 - 07:01
User Badges:
  • Purple, 4500 points or more

You can use the command "csim start ". This is a hidden command in IOS.


Hope this helps.


Brandon

Nicholas Matthews Thu, 04/02/2009 - 10:14
User Badges:
  • Red, 2250 points or more

You may find csim start to work, but generally it doesn't work for IP trunks. It's an older command that assumes you have a analog connection.



Best way is to configure it for CME and register a phone to it. But if you don't have a phone, you're kind of out of luck.


I do a lot of voice troubleshooting, and I can count the number of times csim start has been helpful on one hand.



-nick

Brandon Buffin Thu, 04/02/2009 - 10:52
User Badges:
  • Purple, 4500 points or more

Good tip, Nick. I do normally use csim start to test analog connections and it works great. I assumed it would work on IP connections as well.


Brandon

Actions

This Discussion